Arzum MAXIBLEND AR 1057, Manual, Page: 10 / 29

18 ARZUM
19 ARZUM
• When removing the grinder reservoir and chopper reservoir, first
remove the reservoirs from the motor base, then remove the grinder
reservoir knife headpieces and chopping knife pieces from the grinder
reservoir by turning them clockwise and finally remove the gasket ring
and the knife cap group.
• Rinse the measuring cup, lid, jug, gasket ring, knife assembly, grinder,
grinding knife headpieces and chopping knife headpieces manually or
in a dishwasher and then dry. It is washable in the dishwasher, but the
temperature setting should not exceed 70° C.
• Use hot soapy water to rub the knife and then
rinse thoroughly under the tap. Do not touch sharp
knives, use with care. Do not immerse the knife
assembly, grinding knife headpieces and chopping
knife headpieces in water. Leave it upside down
in a place where children can
not reach.
• Wipe the surface of the
motor unit with a damp cloth and dry thoroughly.
Remove stubborn stains with non-abrasive cleaner
by rubbing. If liquid is spilled on the motor unit, first
unplug the device, then wipe it with a dry cloth and
dry thoroughly.
WARNING
• Do not immerse the motor unit in the liquid to prevent an electric
shock risk.
• Do not use scouring sponges or cleaners on parts or the base.
• Do not place the motor base in the dishwasher to clean it. This
appliance is not suitable for dishwashers.
Note: For each use, the consecutive operation time must not exceed
30 seconds. Wait at least 10 minutes between two continuous cycles;
Wait for the grinder reservoir to return to room temperature before
performing the next startup operation.
Use of Chopper:
• Turn the chopper reservoir
by rotating the chopping knife
headpieces and place it on a
flat surface with the open side
pointing up
• Put the material to be
processed in the chopper
reservoir (approx. ≤100 g) and lock the chopping knife headpieces (seal
ring inside) firmly, then secure it to the motor unit;
• Plug the power cord into a standard wall outlet;
• Turn the speed knob to speed 2 (usually about 30 seconds required),
depending on the job you will be doing.
When the desired effect is obtained, move the knob to position 0.
Note: For each use, the consecutive operation time must not exceed
30 seconds. Wait at least 10 minutes between two continuous cycles;
Wait for the unit to return to room temperature before performing the
next cycle of operation.
MAINTENANCE AND CLEANING
• Unplug the blender before cleaning.
• For easier cleaning, always wash immediately after use. Do not allow
food to dry in the jug, which makes cleaning difficult.
• Pour a little warm foamy water into the jug and set the knob to
position P for a few seconds. And then empty the jug.
• Remove all removable
parts. To remove the knife
assembly from the base of
the jug by turning it clockwise,
remove the jug assembly from
the engine unit and remove
the seal ring and the knife
assembly.
EN