75
| Customizing IAP Settings
Aruba Instant 6.5.0.0-4.3.0.0 | User Guide
Figure 24
IAP Settings—Provisioning Master IAP
4. Click
OK
.
In the CLI
To provision an IAP as a master IAP:
(Instant AP)# iap-master
To verify if the IAP is provisioned as master IAP:
(Instant AP)# show ap-env
Antenna Type:Internal
Iap_master:1
Adding an IAP to the Network
To add an IAP to the Instant network, assign an IP address. For more information, see
.
After an IAP is connected to the network, if the Auto-Join feature is enabled, the IAP inherits the configuration
from the VC and is listed in the
Access Points
tab.
If the auto-join mode is disabled, perform the following steps by using the Instant UI.
In the Instant UI:
To add an IAP to the network:
1. On the
Access Points
tab, click the
New
link.
2. In the
New Access Point
window, enter the MAC address for the new IAP.
3. Click
OK
.
Removing an IAP from the Network
You can remove an IAP from the network by using the Instant UI, only if the Auto-Join feature is disabled.
