Figure 55
Tunnel Configuration
c. Enter the primary server IP address in the
Primary Peer address
text box.
d. Enter the remote end backup tunnel IP address in the
Backup Peer address
text box. This is an
optional text box entry and is required only when backup server is configured.
e. Enter a port number in the
Peer UDP port
text box.
f. Enter the remote end UDP port number in the
Local UDP port
text box. The default value is 1701.
g. Enter the interval at which the hello packets are sent through the tunnel in the
Hello interval
text box.
The default value is 60 seconds.
h. Select the message digest as MD5 or SHA to be used for message authentication from the Message
digest type drop-down list.
i.
Select
Disabled
from the
Checksum
drop-down list.
j.
Enter a shared key for the message digest in the
Shared Key
text box. This key should match with the
tunnel endpoint shared key.
k. If required, select the failover mode as Primary or Backup (when the backup server is available).
l.
Specify a value for the tunnel MTU value if required. The default value is 1460.
m. Click
OK
.
4. Configure the session profile:
a. Enter the session name to be used for session creation.
Figure 56
Session Configuration
Aruba Instant 6.5.0.0-4.3.0.0 | User Guide
VPN Configuration |
236
