Aruba AP-60, Installation Manuals

Page: 9 / 36

Introduction 3
Chapter 1
Antenna fixtures for Wireless Communications
Depending on the model, the AP will have one of the following:
Aruba AP60–Two Reverse Polarity SMA (RP-SMA) connectors for attaching
separate antennas (not included). For details, see
“Aruba 60 Detachable
Antennas” on page 24 . (The AP60 requires that both connectors be used in
ArubaOS 2.2 releases or lower. Single antenna operation is supported with
ArubaOS 2.3 or higher.)
N
OTE
— When facing the A60 as shown in Figure 1-1 , the antenna connector on the
left is for antenna 1, and the connector on the right is for antenna 2 in a diver-
sity configuration.
Aruba AP61–Built-in swivel array with dual, tri-band, omnidirectional antennas
Indicator LEDs
During operation, the Aruba AP60/61 LEDs provide the following information:
N
OTE
— LEDs on the Mobility Controller provide additional status and security
information about connected APs.See the ArubaOS User Guide for
more information.
Air Vents
These vents promote proper air circulation for cooling the device. Do not allow
these vents to be obstructed by mounting equipment, network cables, or any
other material.
T
ABLE
1-1 Aruba AP60/61 LEDs
LED State Description
PWR Off The device is off - no power.
Green-Solid The device is powered and operating.
ENET Off No link on the FE port. No connection to the
network.
Green-Solid Ethernet link detected on the FE port.
Green-Flashin
g Transmitting or receiving data across the FE
port. Flashing rate is proportional to network
activity.
WLAN
Off The wireless interface is disabled or down.
Green-Solid The wireless interface is enabled and
functioning as an Access Point.
Green-Flashin
g The wireless interface is enabled and
functioning as an Air Monitor.
1
A
B
2
A
B
C
3