Aruba AP60/61: Installation Guide
14
Part 0500034-05
May 2005
6
Plug the AP into one of the ports configured for provisioning.
If your AP is already plugged into the port, unplug it and plug it in again.
If AP is connected through POE, enter (in interface mode)
no
poe
followed by
poe
.
The AP will come up with an IP from the provisioning subnet
After the AP comes up it should be in the provisioning list. Provisioning list
shows the list of APs which are plugged into the provisioning ports.
7
The
Clear Table
button appears after an entry in the list appears.
To erase all the table entries, click
Clear Table
. (You cannot clear selected
entries.) If a number of APs are provisioned and you click
Clear Table
, only the
entries which come up afterwards can be provisioned.
If the entry does not show up in the AP list, check network connectivity. Go to
the AP console and verify if the AP has come up with the IP from the
provisioning subnet.
8
After the entry shows up on the page, configure the
location
,
Host
IP/Name,
Master IP address
.
If AP is going to be assigned a static IP, click
Use the following IP Address
and
enter the
IP address
,
Netmask
,
Gateway IP
.
If the AP is going to obtain an IP address using DHCP, click
Use IP Address
Using DHCP
.
9
After configuring the required parameters, select the entry from the list (AP
to which the configuration has to be applied) and click
Apply
.
The State field changes from
U
(
Unprovisioned
) to
In Progress
. to
P
(
Provisioned
).
N
OTE
—
Check that the configured parameters are reflected in the AP list entry.
N
OTE
—
Aruba Networks recommends that you provision each AP for a unique location as suggested
by site-survey planning. Label each AP with this location information and place the AP in its
proper location. Failure to place APs in the location for which they were provisioned will reduce
the effectiveness of such RF features as triangulation.
10 Click
Back
to return to the previous page
We can see that the Subnet is still configured and Port/s are selected.
11 When finished provisioning APs, click
Disable
to disable AP Provisioning.
N
OTE
—
Disable AP Provisioning after all the required APs are provisioned. Ports that are enabled for
provisioning do not handle traffic. Therefore plugging an already provisioned AP into a port still
set to provisioning mode will prevent that AP from functioning.
Now the AP is configured with the Parameters given
Summary of Contents for AP-60
