Aruba AP-60, Installation Manuals

Page: 26 / 36

Aruba AP60/61: Installation Guide
20 Part 0500034-05 May 2005
N
OTE
— The
master
and
serverip
environment variables also affect how source files are
selected and should be cleared when using this approach. To clear a variable,
enter the
setenv
variable
command with no host or address value.
When finished, proceed to Step 2.
z
My network uses direct IP addresses instead of DNS.
If using direct IP addresses in your network, use the following com-
mands:
N
OTE
— If the
servername
variable is configured in this scenario, it will be ignored.
2 Specify an IP address for a specific AP, if necessary.
If using DHCP, the AP will obtain its IP address automatically and you can skip
this step. Otherwise, configure the AP with a static IP address using the
following commands:
3 Set the location for the specific AP, if necessary.
Location settings depend on how much control you want over configuring
logical groups of APs in the future.
z
Default Locations
If you wish all APs treated as a single entity for configuration and
accounting purposes, you can use the default location profile
(255.255.65535) and skip to Step 5.
N
OTE
— If using default locations during initial provisioning, you can later reconfigure
the APs to use specific location IDs using the Aruba Mobility Controller man-
agement tools.
apboot> setenv serverip
<Mobility Controller IP address>
apboot> setenv master
<Mobility Controller IP address>
apboot> setenv ipaddr
<static IP address for the AP>
apboot> setenv netmask
<static IP address mask>
apboot> setenv gatewayip
<default gateway IP address>