8
| 9240 Gateway
Aruba 9240 Gateway
| Installation Guide
SFP28 Ports
The 9240 is equipped with four SFP28 1G/10G/25G data ports. These ports are labeled as 0, 1, 2 and
3. These ports are intended for use with Aruba supported SFP/SFP+/SFP28 modules.The ports
support three speed (1G, 10G, or 25G) operation.
SFP28 Port LEDs
Each SFP28 port is equipped with two LEDs that allow you to monitor the status of and activity on the
port. These LEDs provide basic monitoring of the status, activity, and basic configuration of each port.
The STATUS LED behavior can be changed using LCD.
LINK/ACT
: on the left side of the port, displays the link status of the port.
STATUS
: on the right side of the port, displays the status of the port. The information displayed by
this LED changes based on LCD’s mode. The LED behavior for each mode is described in
14
PSU Slot 1
Slot for additional power supply module
Table 3
Aruba
9240
Gateway Components (Continued)
Callout Component
Description
Page
Aruba tests and supports Aruba optics within their gateway systems. Third party optics are not tested or
supported; therefore, Aruba does not guarantee proper functionality of third party optics when used in an
Aruba system.
Table 4
SFP28 Port LEDs
LED
Function
LCD Mode
Indicator
Status
LINK/ACT
Link status
N/A
Green (Solid)
Link has been established
Green (Blinking) Port is transmitting or receiving data
Off
No link
STATUS
Port status
Administrative
Green (Solid)
Port Enabled
Off
Port Administratively Disabled
Duplex
Green (Solid)
Full-duplex
Off
Half-duplex
Speed
Green (Solid)
25 Gbps
Blue (Solid)
10 Gbps
Amber (Solid)
1 Gbps