background image

Aruba 387 Series Outdoor Access Points

| Installation Guide

9

Connect the equipment to an outlet on a circuit different from that to which the receiver is connected.

Consult the dealer or an experienced radio or TV technician for help.

Canada

This device complies with ISED’s license-exempt RSS standard(s).

Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) this 

device must accept any interference, including interference that may cause undesired operation of the device. 

When operated in the 5.15 to 5.25 GHz frequency range, this device is restricted to indoor use to reduce the 

potential for harmful interference with co-channel Mobile Satellite Systems. 

Déclaration d’Industrie Canada

Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio exempts de 

licence. L'exploitation est autorisée aux deux conditions suivantes : (1) l'appareil ne doit pas produire de 

brouillage, et (2) l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage 

est susceptible d'en compromettre le fonctionnement.

Professional Installation Instruction

This product is designed for specific application and needs to be installed by a qualified personal who has RF and 

related rule knowledge. The general user shall not attempt to install or change the setting.

Please carefully select the installation position and make sure that the final output power does not exceed the 

limit set force in relevant rules. The violation of the rule could lead to serious federal penalty.

Instructions d'installation professionnelle

Ce produit est destine a un usage specifique et doit etre installe par un personnel qualifie maitrisant les 

radiofrequences et les regles s'y rapportant. L'installation et les reglages ne doivent pas etre modifies par 

l'utilisateur final.

Choisir avec soin la position d'installation et s'assurer que la puissance de sortie ne depasse pas les limites en 

vigueur. La violation de cette regle peut conduire a de serieuses penalites federales.

EU Regulatory Conformance 

Aruba hereby declares that the 387 Series wireless access points are in compliance with directives listed 

below

:

Radio Equipment Directive 2014/53/EU

REACH Regulation (EC) No.: 1907/2006

RoHS Directive 2011

WEEE Directive 2012

The Declaration of Conformity made under Radio Equipment Directive 2014/53/EU is available for viewing at: 

www.hpe.com/eu/certificates

. Select the document that corresponds to your device’s model number as it is 

indicated on the product label.

This device intended to be installed outdoors.

Radio Type Frequency Range

Power (EIRP)

Modulation

BLE

2400-2483.5MHz

<10dBm

GFSK

802.11

5150-5250MHz

23dBm

OFDM

802.11

5250-5350MHz

23dBm

OFDM

802.11

5500-5720MHz

30dBm

OFDM

802.11

5725-5850MHz

14dBm

OFDM

802.11ad

57-66GHz

40dBm

OFDM

Summary of Contents for 387 Series













Reviews: