4
RCC 300 SUBWOOFER MODULE (RCC300-SM)
The RCC 300 Subwoofer Module can be installed into either an:
Artison Pre-Build Box (Volume
≈
0.6 ft
3
)
SOLD SEPERATELY
OR
Infinite Baffle (i.e. 2x4 stud wall, 16” On Center spacing
at least
4 feet tall, Volume 1.4 ft
3
or greater
)
IMPORTANT:
In an installation of two RCC300-SM’s that are being powered by one
RCC300-SA, both Subwoofer Modules need to be in either Pre-Build Boxes or be in
Infinite Baffles.
You cannot connect two RCC 300 Subwoofer Modules that are in
different environments to the same RCC 300 Subwoofer Amplifier.
The front of the RCC300-SM and the grille can be painted. The RCC300-SM comes from the
factory with a paint-shield attached. When painting the RCC300-SM, ONLY paint the grille and
outer edge of the module using the included paint-shield.
DO NOT get paint on the rear of the
subwoofer module. Paint can damage the components which would VOID your Warranty.
The minimum mounting depth for the RCC300-SM is 3¾” (95.5 mm), i.e. a 2x4 stud is 3½” deep
add ¼”, ½” or
⅝
” thick drywall and the RCC300-SM will fit. The maximum drywall thickness the
RCC300-SM can be mounted in is 1.3125” (33.3 mm).
INSTALLATION WITH AN ARTISON PRE-BUILD BOX
(Preferred Installation)
1.
Please refer to the Installation Guide included in the Artison Pre-Build Box Carton for
installation instructions for your Artison Pre-Build Box.
2.
Using the speaker wire already run inside the Pre-Build Box, manage the speaker wire around
the RCC300-SM.
3.
Connect the bare speaker wire ends to the spring-loaded binding posts.
4.
Install the RCC300-SM into the pre-cut opening of the Pre-Build Box.
5.
Carefully tighten the four dog leg clamps on the RCC300-SM using a #2 Philips Head
Screwdriver
.
6.
The grille for the RCC300-SM is held in place by magnets. Simply position the grille on the
front of the module into the recessed area.
NOTE: While installing the subwoofer module make sure that any excess wire is run
properly so that it does not interfere with the driver’s operation. The design of
the RCC300-IWPBB is such that there is NO clearance between the back of the
subwoofer module and the back of the box. Be careful that no wires are in this
