Adding an additional remote control or
“cloning” a channel
A previously programmed remote control can be used in order to add a new remote control or
operating channel. Also, you can copy one channel to another in the same remote control using
this procedure.
Changing to tilt or jog mode
Tilt or jog mode
initiates a short motor movement when pressing the up or down buttons.
The
tilt or jog mode
is convenient for Venetian Blinds, Wood Blinds and Dual Shades since it
allows the jogging of the slats in a more precise way. When this mode has been programmed,
the
up
or
down button
must be pressed for
3 s
to make the motor move continually to its upper
or lower limits, otherwise when you press the
up
and
down button
the motor will do short
movements.
Repeat the same procedure if you want to erase the
tilt or jog mode
.
2.
Release the
stop button
and press it again for
about
2 s
. The motor will
“jog”
again.
The
tilt or jog mode
has been programmed.
1.
Press and hold the
stop button
for about
5 s
until the motor
“jogs”
.
STOP
BUTTON
STOP
BUTTON
1.
Using the previously programmed
remote,
select the desired channel using the
channel
selector button
, then press and hold
the
stop
button
for about
5 s
until the motor
“jogs”
.
2.
U
sing the new remote, select the desired
channel using the
channel selector button
, and
then press the
up button
until the motor
“jogs”
.
hades are now paired with the new remote or
channel.
STOP
BUTTON
UP
BUTTON
PREVIOUSLY
PROGRAMMED
REMOTE CONTROL
NEW REMOTE
CONTROL
OR CHANNEL
6
