Veneer Guide (Optional)
The DB2 device is available in a special version that is prepared to be
mounted from below the table with a Veneer finishing on the top of the
monitor to match the table. The Veneer is not supplied
The Veneer can be placed in three
ways (Dimensions are specified in the corresponding “Pattern Hole” document
):
VENEER
INTRODUCTION
9
Veneer: The veneer thickness must be
5mm [0,16
–
0,19]. A mechanized
blind hole will be necessary to hide
the touch button copper cylinder.
Distance Plate: For Veneers
Thickness of 1mm [0,04] or less. It will be
necessary a Distance Plate to hide the
touch button copper cylinder.
Veneer
Distance Plate
Option2:
Option3:
Option1:
Veneer: In order to adjust the plastic
touch button height, V
Glue/tape thickness must be previously
communicated.
Veneer
