950-0052-01r0_fmt_en-US
13 of 20
Adjust
the Set Pressure slider to the surgeon’s desired value (note: as you adjust the slider the
numerical value appears to the right of the slider). Finally, choose one of the three options for the
surgical display. If
“
On
” is selected the pump pressure appears on the surgical monitor at all times. If
“
Off
” is selected the pump pressure is only displayed prior to the start of the case and never appears
on the monitor during the case. If
“
On Change
” is selected the pump change data appears on the
surgical monitor only when the data changes. In this case it disappears from the monitor after
displaying for several seconds. Touch Save after the changes have been made.
Figure 6. Shaver tab
Select the Shaver tab (as shown in Figure 6) if the shaver will be used with the procedure.
Adjust the Fwd
/Rev Set Speed and Osc. Set Speed sliders to the surgeon’s desired value (note: as
you adjust the slider the numerical value appears to the right of the slider). Next, choose the preferred
Set Mode for the procedure using the drop down options. Finally, choose one of the three options for
the surgical display. If
“
On
” is selected the shaver speed appears on the surgical monitor at all times.
If
“
Off
” is selected the shaver speed is only displayed prior to the start of the case and never appears
on the monitor during the case.
If “
On Change
” is selected the shaver changed data appears on the
surgical monitor only when the data changes. In this case it disappears from the monitor after
displaying for several seconds. Touch Save after the changes have been made.
Figure 7. RF tab
Select the RF tab (as shown in Figure 6) if the RF will be used with the procedure.
