3
When unpacking and before disposing of the carton check there is no transportation damage
before using the projector. Should there be any damage caused by transportation, consult your
dealer and do not use the apparatus.
The projector is for indoor use only, IP20. Use only in dry locations. Keep this device away from rain
and moisture, excessive heat, humidity and dust. Do not allow contact with water or any other
liquids.
DO NOT mount the projector directly onto inammable surface
The projector is only intended for installation, operation and maintenance by qualied personnel.
The projector must be installed in a location with adequate ventilation, at least 50cm from
adjacent wall surfaces. Be sure that no ventilation slots are blocked.
Do not project the beam onto inammable surfaces, minimum distance is 5m 5m
Avoid direct exposure to the light from the lamp. The light is harmful to the eye. Do not attempt to
dismantle and/or modify the projector in any way.
Electrical connection must only be carried out by qualied personnel.
Before installation, ensure that the voltage and frequency of power supply match the power
requirements of the projector. It is essential that each projector is correctly earthed and that
electrical installation conforms to all relevant standards.
Do not connect this device to any other types of dimmer apparatus.
Make sure that the power-cord is never crimped or damaged by sharp edges. Never let the
power-cord come into contact with other cables. Only handle the power-cord by the plug. Never
pull out the plug by tugging the power-cord.
Keep a projector’s optical system clean. Do not touch LED lens with bare hands.
The projector should always be installed with a secondary safety xing. A safety cord is supplied for
this; it should be attached as shown in “installing the projector” section.
Shields and lens shall be changed if they have become visibly damaged to such an extent than
their effectiveness is impaired, for example by cracks or deep scratches.
LED lamps should be replaced if damaged or having reached life limit.
Exterior surface temperatures of the luminaire after 5 minutes operation is 55
℃
, when steady state
is achieved 70
℃
,
There is no user serviceable parts inside the projector, do not open the housing and never operate
the projector with the covers removed.
If you have any questions, don’t hesitate to consult your dealer or manufacturer.
SAFE USAGE OF THE PROJECTOR
14
TECHNICAL DATA
POWER SUPPLIES
Input Voltage: AC90 -240V 50-60Hz
Power Consumption: 230W
LAMP SOURCE
Red Buttery 150W RGBW LED Module
80,000 Hour Average LED Engine Life
COLOR SYSTEM
RGBW Full Color ( without color wheel )
EFFECTS SECTION
2 Gobo Wheels:
One Fixed Gobo Wheel:7 gobos(5 2 gopen
One Rotating Gobo wheel:7 gobos(5 2 gopen
Electronic Focus
High speed shake effect
3-facet rotating prism
Mechanical shutter and adjustable speed strobe effect (1Hz~13Hz)
Linear dimmer
CONTROL AND PROGRAMMING
Max 24 DMX 512 control channels
DMX protocol signal: USITT DMX 512
Display: LCD Display
Pan/Tilt Resolution: 16 bit
DMX signal connection: 3 pole XLR input and output
BODY
Aluminium structure with die-cast plastic cover
Two side handles for transportation
Device locking PAN and TILT mechanisms for transportation and maintenance
MOVING BODY
Travel: PAN = 540° TILT = 270°
CONTROL MODE
DMX512/Master-slave/Auto
COOLING SYSTEM
Convective Fan Inside
NET WEIGHT
14 Kg
GROSS WEIGHT
16 Kg
PACKING SIZE
72x45x43 (cm)
Zoom
12° - 15°
