GB
2 - Fitting the upper support plate:
Remove the 2 black plastic seals. Position and screw the plate
using 2 M5x15 screws. Remove the hinge cover.
Flush fitting
Where flush fitting your wine cabinet with other
furniture
Ensure that the base of the furniture is completely stable so as to not damage
the appliance. Ensure that the appliance is well ventilated by observing the
dimensions in the drawing. It is essential to have a shaft running from the bot-
tom to the top at the rear of the appliance. Where another piece of furniture is
positioned on the Vin&O integrated section, ensure that the shaft extends up
to the top.
3 - Positioning inside the furniture:
Position the appliance inside the furniture, against the right side if the appliance has a
left-hand door, against the left side if the appliance has a right-hand door.
Check that the appliance is stable by verifying that the 2 front feet are fully in contact
with the surface of the furniture, in order to avoid any warping of the appliance casing
once loaded. If this is not the case, re-screw or unscrew the front feet until they are
fully in contact. The appliance must be positioned so that the front is a maximum of
8 mm away from the surface of the furniture. The cabinet must then be fixed into place
using the upper support plate (2 countersunk screws).
Leave a minimum of 1 mm of play between the mounting of the furniture and the door
of the furniture, to ensure that the appliance is effectively sealed.*
* For technical doors only.
English - P 9
1- Adjusting the feet:
Screw down the 2 back feet, as previously described.
Pre-adjust the front feet: screw or unscrew the front feet in order to level the
appliance (see diagram).
VIEW FROM THE SIDE
Rear feet
Front feet
HORIZONTAL PLANE
Rear metallic section in contact
with the wall or furniture