38
Figure 13. Screw-in Filter Removal
1) Turn off all power to the spa and remove the filter lid by lifting it out towards you.
2) Turn the filter counterclockwise and remove it from the filter well.
3) Clean or Replace the filter.
4) To replace, set screen back into its place and turn clockwise to fasten. DO NOT
over-tighten.
5) Place the new filter into position and turn clockwise to fasten. DO NOT
overtighten.
6) Use of a quality filter soak product is recommended. Please contact your dealer
to purchase spa care products.
NOTE: Only use Garden Spas™ approved filters. Using a Non Garden Spas™
approved filter can cause issues with the circulation system and heater and can
void warranty coverage. The filter can be upgraded to a 75 Sq. ft. filter. Please see
your Garden Spas™ dealer, Part # 06-007-12 (standard) or 06-008-12 (Nature2)
option.
WARNING: Power to the spa must be turned off prior to removing the filters. The
suction at the filter is extremely strong and can cause injury if there is no filter.
NEVER run the spa without the filters properly installed. Injury to person and
damage to the equipment can occur. Any damage to equipment due to this
circumstance will not be covered under warranty.
Storing or Winterizing the Spa
An emptied spa (without water) must not be exposed to direct sunlight as acrylic shell
damage may occur to UV radiation. It is not recommended that the spa be drained
completely during freezing conditions. Leaving the spa full of water with the power on is
recommended to keep the tub from freezing. If you decide to drain the spa during
freezing conditions, contact your local authorized dealer for assistance.
Summary of Contents for Garden Spas
