Artesian Spas Garden Spas, Owner'S Manual

Page: 20 / 54

17
ELECTRICAL REQUIREMENTS
The following information is provided for guidance alone in connecting the electrical
power supply to the new spa.
A qualified, licensed, electrician must perform this
work. Failure to follow these instructions will terminate all warranty coverage and
could result in serious injury or death.
Garden Spas™ are preset at the factory to run on 120 V, 60 Hz with a 15 A input. This
provides for the best performance of the spa. If ordered 240 V, then it will be wired for
240 V, 4 wires, 32 A maximum.
Codes and Compliance
North America – 60 Hz
240 VAC
32 A
4
40 A
Voltage
Maximum Current
Number of Wires
GFCI Rating
Export 50 Hz Garden Spas™ are factory preset to run 240 V, 3 wires, 32 A maximum
input. This product must always be connected to a residual current device (RCD) having
a trip current of not more than 30 mA.
SPA START-UP
Please read each step of the Start-up section prior to performing the step.
Selecting a Location
General Guidelines
In preparation for installing the new Garden Spas™ spa, ensure that the following
general guidelines are considered:
Artesian Spas™ (May Manufacturing, LLC.) highly recommends consulting a
qualified licensed contractor, engineer and/or architect prior to the installation
of any spa to ensure safety, compliance with national, state and local building,
electrical and plumbing codes and to account for local geotechnical and
environmental conditions. For further assistance, please contact your
authorized Garden Spas™ Dealer.
1. Place the spa on a structurally sound and level surface that is large enough for
the entire spa. Allow additional space for easy access to equipment
North America – 60 Hz
120 VAC
15 A
3
20 A
Voltage
Maximum Current
Number of Wires
GFCI Rating