27
Priming Pumps
1. Turn off power at electrical service panel.
2. Locate and loosen the pump union by turning it counterclockwise one half of one
turn.
3. Allow air to escape from the fitting. When a steady stream of water flows from the
pump union, close it by turning it clockwise until tight.
4. Turn on power at electrical service panel.
5. Perform one additional check to ensure water is flowing from the jets during the
auto purge cycle. If so, continue to Water Preparation. If no water flow is coming
from the spa jets, please call your Garden Spas™ dealer for further assistance.
Water Preparation
Proper understanding of the treatment of fresh water prior to use is an important part of
maintenance and is one of the key aspects enabling worry free usage. Failure to
properly prepare the water can result in substantially decreased life of the components
and may void the warranty in severe cases. Please consult your local Garden Spas™
dealer in regards to appropriate start-up and maintenance kits available when
purchasing the spa.
TOPSIDE CONTROLLER INSTRUCTIONS
Figure 4. Garden Spas™ Topside Controller Face
Summary of Contents for Garden Spas
