Artecta Domotion DLC-4 RGB, Manual

Page: 9 / 16

8
Ordercode: A9915060/A9915061
Domotion DLC-4 RGB
Installation
Remove all packing materials from the Domotion DLC-4 RGB. Check if all foam and plastic padding is
removed. Connect all cables.
Do not supply power before the whole system is set up and connected properly.
Always disconnect from electric mains power supply before cleaning or servicing.
Damages caused by non-observance are not subject to warranty.
Set Up and Operation
Follow the directions below, as they pertain to your preferred operation mode.
Before plugging the unit in, always make sure that the power supply matches the product specification
voltage. Do not attempt to operate a 120V specification product on 230V power, or vice versa.
Setup example
Follow the instructions below for a proper way to setup the DLC-4 (see Fig. 03).
01)
Connect the DLC-4 with the required 12V or 24V power supply.
02) Connect the DLC-4 with RGB light fixtures (max 6A).
03) Connect the required 12V or 24V power supply to a DMX dimmerpack.
04) Connect the DLC-4 with the dimmerpack using the DMX out.
05) Connect the dimmerpack with the RGB light fixtures.
Fig. 03
06)
Mount the DLC-4 on a wallbox, see Fig. 04.
Fig. 04