13
Ordercode: A9915060/A9915061
Domotion DLC-4 RGB
Problem
Probable cause(s)
Solution
The unit does not
function at all
No power to the unit
•
Check if the unit is connected to
the power supply
Bad cable connection
•
Inspect connections and cables.
Correct poor connection. Repair
or replace damaged cables.
Fixtures reset
correctly, but all
respond
erratically or not
at all to the
controller
The controller is not connected.
•
Connect controller.
3-pin DMX Out of the controller
does not match DMX Out of the
first fixture on the link (i.e. signal is
reversed)
•
Install a phase reversing cable
between the controller and the
first fixture on the link
Fixtures reset
correctly, but
some respond
erratically or not
at all to the
controller
Poor data quality
•
Check data quality. If much lower
than 100 percent, the problem
may be a bad data link
connection, poor quality or
broken cables, missing termination
plug, or a defective fixture
disturbing the link
Bad data link connection
•
Inspect connections and cables.
Correct poor connections. Repair
or replace damaged cables
Incorrect addressing of the fixtures •
Check address setting
One of the fixtures is defective and
disturbs data transmission on the
link
•
Bypass one fixture at a time until
normal operation is restored:
unplug both connectors and
connect them directly together.
•
Have the defective fixture
serviced by a qualified technician
3-pin XLR Out on the fixtures does
not match (pins 2 and 3 reversed)
•
Install a phase-reversing cable
between the fixtures or swap pin 2
and 3 in the fixture that behaves
erratically
No light or LEDs
cuts out
intermittently
Fixture is too hot
•
Allow the fixture to cool down
•
Clean the fan
•
Turn up the air conditioning
LEDs damaged
•
Disconnect the fixture and return it
to your dealer
The power supply settings do not
match local AC voltage and
frequency
•
Disconnect fixture. Check settings
and correct if necessary
Summary of Contents for Domotion DLC-4 RGB
Page 16: ... 2017 Artecta ...
