12
Display Track Fresnel 20 SW
Product code: A0320140 / A0320141
05)
Select the circuit with the circuit selector (03). You can select 1-, 2- and 3-phase circuit, as shown in
Fig. 09.
Attention
Do not slide the track adapter in the track to adjust the position of the device (see Fig. 10). This can
damage the connectors. Remove the device from the track and install it at the new place. For more
information on how to remove the device from the track, refer to 4.8. Dismounting on page 14.
Fig. 09
Fig. 10
Direction Adjustment
To adjust the angle of the device and the direction of the beam, follow the steps below:
01)
Pivot the device around the track adapter (01) to adjust the direction of the beam (see Fig. 11).
02)
Turn the adjustment handle (11) counterclockwise to release it.
03)
Tilt the device at the desired angle (see Fig. 12).
04)
Turn the adjustment handle (11) clockwise to tighten it. Make sure that the device cannot move
freely after the adjustment handle (11) is tightened.
Fig. 11
Fig. 12
Summary of Contents for A0320140
Page 20: ...2020 Artecta...