11
Spade Connector
– Loosen the red and black caps on the binding
posts (don’t completely remove). Insert the spade connector into the
binding post and tighten the caps down on the spade connector. Be
sure that the wire connected to one post does NOT come in contact
with that of another post.
Banana Plug
– Insert the banana plugs into the caps of the binding
posts. Be sure that the red and black caps on the binding posts are
tightened down completely and that they are securely connected to
avoid the possibility of the banana plugs from popping out.
SMARTFAN™
The SLA-2 features SmartFan™, an advanced, thermal dependent fan
assisted convection cooled system. The SmartFan™ system is
dependent upon the internal ambient temperature inside the unit, and
runs at two different levels. The SmartFan™ system is extremely quiet.
Do not block the fan or constrict air circulation. Doing so may cause
the amp to overheat and/or shutdown.
FUSE
The SLA-2 utilizes a (T10A 250v 20mm) 10 Amp fuse. Be sure to
replace any blown fuses with a fuse of equal rating only.
AC POWER INPUT
The SLA-2 features an internal power supply. Plug the detachable
cable into a standard wall outlet. Be sure that the supplied voltage
matches that of the required voltage labeled on your amplifier. Never
plug the amp into an outlet that does not match the required voltage of
your amplifier. Serious damage could result.
