background image

INSTALLATION 

The ART CX310 may be used in a wide variety of applications and environments. Enclosed in a 1U 

(1.75 inches high) rack-mountable, all-steel enclosure, the unit is designed for continuous 

professional use. The depth is 6.5 inches, exclusive of the power cord. Mounting location is not 

critical. However, for greater reliability, we recommend that you not place the unit on top of power 

amps or other sources of heat. 

AC POWER HOOKUP 

The CX310 has an internal power supply designed to operate from 105 to 120VAC at 50/60Hz. 

Export units are configured with a different power cord and the voltage switch is set for the country of 

destination. Before plugging the CX310 into the AC mains, make sure that all of the equipment 

following the crossover outputs are turned off or that all of the outputs are turned down. 

INPUT/OUTPUT CONNECTIONS 

The CX310 has XLR and 1/4" TRS phone jack connectors for each input and output. All connections 

are active balanced although the 1/4" phone jack connections can easily be converted to unbalanced 

operation by using two-conductor phone plugs. Inserting a plug into a 1/4" jack disconnects the 

associated XLR connector. 

MONO 3-WAY CONFIGURATION 

This information is intended to clarify how the CX310 is used in the mono 3-way configuration. 

Connections: 

Input  

 

 

Channel One INPUT 

   

 

 

(Channel Two INPUT not used) 

Low Output 

 

Channel One LOW OUTPUT 

Mid Output 

 

Channel Two LOW OUTPUT 

High Output 

 

Channel Two HIGH OUTPUT 

   

 

 

(Channel One HIGH OUTPUT not used) 

Controls: 

Input Level 

 

Channel One INPUT LEVEL control 

Low Output Mute 

Channel One LOW MUTE switch 

Low Output Level 

Channel One LOW OUTPUT LEVEL control 

Low/Mid Crossover 

Channel One RANGE switch and FREQUENCY control 

   

 

 

(Channel One HIGH MUTE switch and  

   

 

 

 HIGH OUTPUT LEVEL control not used) 

   

 

 

(Channel Two INPUT LEVEL control not used) 

Mid Output Mute 

Channel Two LOW MUTE switch 

Mid Output Level 

Channel Two LOW OUTPUT LEVEL control 

Mid/High Crossover  Channel Two RANGE switch and FREQUENCY control 

High Output Mute 

Channel Two HIGH MUTE switch 

High Output Level 

Channel Two HIGH OUTPUT LEVEL control 

Summary of Contents for CX310













Reviews: