The front floor frame is made up of
three pieces. The side floor frames
and the rear floor frame are made up
of two pieces. The holes in these
pieces will align when the pieces are
positioned with correct amount of
overlap. The illustrations below show
the proper overall length for the sides,
rear and front. Proceed as follows:
1
Place the
front floor frames
as
shown. Center the
ramp,
with drain
holes facing outside,
on top of the two
front floor frames. Join the frames by
inserting eight screws.
2
Overlap the
side floor frames
and
the
rear floor frames
as shown. The
holes in these pieces will align when
the pieces are positioned with cor-
rect amount of overlap. See the illus-
trations below for the proper overall
length of the side and rear floor frames.
Join the frames by inserting four/five
bolts into each frame set as shown.
3
Double check the length of each
and set these pieces aside for later
use.
Step 1
SV14
●
Parts Needed For
●
Floor Frame Assemblies
●
●
●
●
●
8934 Ramp (1)
●
●
●
●
●
9367 Front Floor Frame (2)
●
●
●
●
●
8936 Rear Floor Frame (2)
●
●
●
●
●
10392 Side Floor Frame (4)
14
9367
STEP
1
8934
9367
DRAIN HOLES FACE
OUTSIDE
Front Floor
Frame Assembly
119 3/8" 303,2 cm
8936
10392
9367
8934
9367
10392
10392
Side Floor Frame 141 5/8" 359,7 cm
8936
8936
Rear Floor Frame 119 3/8"
303,2 cm
STEP
2
STEP
3
141 5/8" 359,7 cm
141 5/8" 359,7 cm
119 3/8" 303,2 cm
Front & Rear
119 3/8" 303,2 cm
Sides
