Step 13
A26et ctr
Parts Needed For
Right Roof Panel
8468 Right Roof Panel (1)
Installing the roof panels is best done
with a step ladder. Begin installing
roof panels at the back right corner
of the building. Each screw and bolt
in the roof requires a washer.
NOTE
Measure the building diagonally
again and make adjustments to
make sure the building is square.
This will make the roof panels fi t
better, and holes will align.
NOTE
If a Roof Beef-Up Kit was
purchased, assemble prior to
attaching the roof panels.
1
Locate the roof panels by their
numbers. Note the sequence and
position they are to be installed.
2
Position a right roof panel at the
back right corner and fasten to the
top roof beam using a screw.
3
Remove edge trim from the left
gable under the roof panel.
4
Continue fastening the right roof
panel to the gable and lower roof
beam using screws, bolts and nuts as
shown. Do not fasten the lower end
of the panels to the side wall angles
at this time.
8468 Right Roof Panel
FRONT
Washer
Bolt
G
able
STEP
2
STEP
1
Nut
2
3
4
5
6
1
7
8469
7483
7483
8468
8469
7483
7483
8468
8
6
2
4
1
5
7
3
FRONT
6529
6529
10
9
(2)
(5)
Hint: Follow the fastener sequence
shown for proper alignment.
STEP
3
STEP
4
26
1
Install a left roof panel at the left
rear and right front corner of the roof.
Install a right roof panel at the left
front corner of the roof.
3
Install 2 narrow and 2 wide roof
panels in the sequence and positions
shown on previous page. Do not
fasten the lower end of the panels
to the side wall angles at this time.
Continue weather stripping the ridge
opening.
NOTE
Narrow roof panel crimped rib is
overlapped by wide rib of
adjacent panel where possible.
Step 14
A27 ctr
Parts Needed For
Roof Assembly
8468 Right Roof Panel (1)
8469 Left Roof Panel (2)
7483 Roof Panel (2)
6529 Roof Panel (2)
2
Cut 4 short 2" (5,1 cm) strips off
the roll of weather stripping tape,
and put them aside. Cover the joint at
the peak with weather stripping tape.
Unroll the tape and press it down over
the opening at the ridge as you install
each roof panel. Do not cut the tape
at this time.
NOTE
If roof beam holes do not line up
with the roof panel holes, shift the
building from left to right.
If this does not help, your building
may not be level. Shim the
corners until holes line up.
Do not fasten
at this time
Fasten At
Overlap with
Bolt
Fasten At
Overlap with
Bolt
Screws To
Roof Beam
STEP
STEP
Screws To
Roof Beam
3
8469 Left Roof Panel
7483 Roof Panel
6529 Roof Panel
8468 Right
Roof Panel
Weather Stripping
Tape Roll
7483 Roof Panel
FRONT
6529 Roof Panel
1
STEP
2
(38)
(19)
27
Summary of Contents for MRD108
Page 2: ......
