The front fl oor frame is made up of
three pieces. The rear fl oor frame is
made up of two pieces. The holes
in these pieces will align when the
pieces are positioned with correct
amount of overlap. The illustrations
below show the proper overall length
for the front and rear. Proceed as
follows:
1
Place the
front fl oor frames
as
shown. Center the
ramp,
with drain
holes facing outside,
on top of the two
front fl oor frames. Join the frames by
inserting eight screws.
2
Overlap the
rear fl oor frames
as
shown. The holes in these pieces will
align when the pieces are positioned
with correct amount of overlap. See
the illustrations below for the proper
overall length of the rear fl oor frame.
Join the frames by inserting fi ve bolts
into frame set as shown.
3
Double check the length of each
and set these pieces aside for later
use.
Step 1
YL11
Parts Needed For
Floor Frame Assemblies
8941 Ramp (1)
9379 Front Floor Frame (2)
9377 Rear Floor Frame (2)
9379
STEP
1
8941
Front Floor
Frame Assembly
95 7/8" 243,5 cm
STEP
2
9379
9377
Rear Floor Frame
95 7/8" 243,5 cm
9377
95 7/8" 243,5 cm Front
95 7/8" 243,5 cm Rear
STEP
3
9377
9379
8941
9379
DRAIN HOLES FACE
OUTSIDE
(8)
(5)
11
Summary of Contents for EPA84
Page 2: ......
