Arris TM02AA104, Installation Manual

Page: 10 / 52

x About this document
Touchstone ARSVD00770 Release 4 Standard 3.0 Aug 2004
Safety requirements
ARRIS Telephony Modems comply with the applicable requirements for
performance, construction, labeling, and information when used as outlined
below:
• Do not use product near water (i.e. wet basement, bathtub, sink or near a
swimming pool, etc.), to avoid risk of electrocution.
• Avoid using and/or connecting the equipment during an electrical storm, to
avoid risk of electrocution.
• Do not locate the equipment within 6 feet (1.9 m) of a flame or ignition
source, to avoid damage or injury from battery explosion (i.e. heat
registers, space heaters, fireplaces, etc.).
• Use only power supply and power cord included with the equipment.
• Equipment should be installed near the power outlet and should be easily
accessible.
Radio Frequency Emissions and Immunity
FCC Declaration of Conformity:
This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. Operation is subject to the following two conditions:
(1) this device may not cause harmful interference, and (2) this device may
accept any interference that may cause undesired operations.
This equipment generates, uses and can radiate radio frequency energy and, if
not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try
to correct the interference by one or more of the following measures:
•
Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and the receiver.
• Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
CAUTION
Make sure that the existing wires providing telephone service are
physically disconnected from the incumbant service provider’s
network interface device. This is a physical break in the
connection, not just a discontinuation of service. Failure to do so
will result in damage to the Telephony Modem.