FIGURE 9 Mounting slots for mounting the bracket to a
pole or pipe
Mounting Q410 to a Junction Box
Perform the following steps to mount Q410 to a Junction
Box.
1. If you are mounting to a junction box, insert two
customer-provided screws through the slots (see
Figure 10) and secure the bracket to the junction box.
FIGURE 10 Attaching the bracket to a junction box
2. Attach Q410 as shown in Figure 8.
Removing Bracket from a T-Bar
Perform the following steps to remove bracket from a T-
Bar.
1. Move the ceiling tiles out of the way.
2. Lift the lever arm of the locking tab and slide the tab
away from the T-bar to release Q410 bracket
assembly from the T-bar (refer Figure 11).
FIGURE 11 Removing the bracket from the T-bar
Q410 and bracket assembly comes away from the T-
bar.
Removing Q410 from the Bracket
Perform the following step to remove Q410 from the
bracket.
Insert the unit removal pin (J in Figure 1) into the hole
on the side of the bracket (see Figure 12) to unlock
the mounting bracket from Q410 enclosure, then
slide Q410 toward the LED Indicator lights and then
pull Q410 away until it detaches from the bracket.
FIGURE 12 Removing the bracket from Q410
Making the Connections
Be sure to use a Cat 5e or better Ethernet cable with non-
booted connectors (see Figure 13). If using PoE+, attach
one end of the Ethernet cable to an 802.3at Type 2-
certified switch or PoE+ injector (sold separately). Attach
the other end of the Ethernet cable to the PoE+ IN port
on Q410 as shown in Figure 14. If using an AC/DC
adapter, connect it to the 48V DC power port in Figure 14
and to an electrical outlet.
If connecting to other APs, connect the enclosed short
Ethernet CAT 5 RJ-45 cable from the PoE OUT port of
Q410 to the PoE in port of the other AP.
NOTE: PoE OUT complies with IEEE 802.3af Power-
over-Ethernet standard. For best performance, it is
recommended to have a separate power source and
PoE cable for Wi-Fi APs with power requirements that
exceed this standard.
Copyright
©
2018 ARRIS Enterprises LLC. All rights reserved.
Page 3 of 4
Published December 2018, Part Number 800-71629-001 Rev D
