FIGURE 4 Attaching the bracket to Q410
4. Clip Q410 and bracket assembly onto the T-bar. Slide
the last locking tab in so that it locks in place around
the T-bar into position 2 (see Figure 5).
FIGURE 5 Attaching the bracket to the T-bar
Aligning Q410 to R510, R610, or R720
Perform the following steps to align Q410 to R510, R610,
or R720.
1. Attach two tabs as shown in Figure 3. The two tabs
should lock in position 1 for R610 and R720 or
position 2 for R510.
2. Attach the bracket to Q410 (see Figure 4).
3. Attach the corresponding band (E, F, or G in Figure 1)
to Q410 using two M3 flat head screws (H in Figure 1)
(see Figure 6). It is recommended to tighten the
screws to 7 in-lbs.
4. Clip Q410, band, and bracket assembly onto the T-
bar. Slide the locking tab so that it locks in place
around the T-bar in position 1 for the R610 and R720
or position 2 for the R510 (see Figure 5).
5. Install R510, R610, or R720 to the T-bar as per their
respective installation instructions.
6. Slide Q410 and the other unit together until the band
contacts the face on both sides (see Figure 6).
FIGURE 6 Aligning Q410 to other APs
Mounting Q410 to a Flat Surface
Perform the following steps to mount Q410 to a flat
surface.
1. If you are mounting Q410 on a flat surface, then you
will also need an electric drill with a 4.75 mm (3/16")
drill bit, and the four No. 8 zinc plated drywall screws
(L in Figure 1) and plastic wall anchors (K in Figure 1)
included with the kit.
2. Remove the three tabs (D in Figure 1) and set them
aside or store them in the original box.
3. Use the secure mounting bracket as a template to
mark the locations for four drill holes on the
mounting surface. There are four screw holes
available on the secure mounting bracket.
4. Line up the bracket and attach to surface with the
drywall screws provided. Make sure the bracket is
oriented as shown in Figure 7.
FIGURE 7 Mounting the bracket to a surface
5. Attach the two shoulder screws (B in Figure 1)
provided using a 2 mm hex wrench or bit to Q410 (A
in Figure 1) as shown in Figure 2. It is recommended
to tighten the screws to 7 in-lbs.
6. Line up the screws with keyholes and slide Q410
away from the LED Indicators. Q410 locks in place on
the bracket (see Figure 8)
FIGURE 8 Attaching Q410 to the Bracket
Mounting Q410 to a Pole using Cable Ties
Perform the following steps to mount Q410 to a Pole
using Cable Ties.
If you are mounting Q410 on a pipe or pole, then feed
two customer-provided cable ties through the slots
on the secure mounting bracket (see Figure 9).
Copyright
©
2018 ARRIS Enterprises LLC. All rights reserved.
Page 2 of 4
Published December 2018, Part Number 800-71629-001 Rev D
