ACM-IP2.1
ANALOGUE SUBSYSTEMS MODULE
User Manual
armtel.com
стр.
15/32
© Armtel
ENG
2 INTENDED USE
The product is designed for continuous round-the-clock operation. The operator’s
intervention is not required after the product’s commissioning except for the following cases:
−
maintenance;
−
product configuration change.
The maintenance personnel shall strictly follow safety rules set in this document.
Before shipping to the customer, the product together with the operational
documentation shall be packed.
2.1 Operating limits
2.1.1 ACM-IP2.1 shall be used at ambient parameters which do not exceed the
permissible values given in 1.3. Moreover, when working with electrical receivers of
up to 1000 V, comply with the safety precautions stated in Occupational Safety Rules
When Operating Electrical Installations.
2.1.2 ACM-IP2.1 can be powered from PoE injector and 48 VDC external power supply
15 W min.
2.1.3 The requirements for operating conditions and the place of installation
given in this document take into account the most typical factors that affect the
operation of the device.
Factors that cannot be predicted, estimated or verified, and which the manufacturer
was unable to factor in during development may exist or arise during operation at the
operating facility.
In the event of such factors, find another operating site where said factors do not exist
or do not affect operation of the product.
2.2 Safety precautions
During installation and operation of ACM, observe safety precautions laid out in local
regulations on electrical safety.
Never operate the product with a damaged power or communication cable.
ATTENTION! NEVER DISMANTLE THE PRODUCT CONNECTED TO MAINS.
