VeriMAG2 User Guide
2
V1.2 2018-01-25
1.
Introduction
1.1. Operating Principle
The VeriMAG2 is a device used to test and verificate the MAGX2 flowmeters in their whole scope of
operation. The process can take place when the meter is installed as well as on uninstalled flowmeter.
The VeriMAG2 is to be wired in between of the sensor and transmitter to measure their status.
1.2. Safety Instructions
Please read this manual carefully before using the product.
Keep this manual for future reference. Arkon Flow Systems, s.r.o will not be liable for any
damage caused by improper use of the product or its accessories.
If the device is used any different way than is specified, the electric protection may be disrupted.
The VeriMAG2 device must not be used in explosive hazardous areas.
1.3. Unpacking
While unpacking the flowmeter, conduct a visual check of the instrument upon receipt to make sure the
product has not been damaged during transport.
Check the completeness of the package. In case of any problem, contact the Arkon sales department
without delay.
o
VeriMAG2 device.
o
Three Cables to connect to the flowmeter.
o
Charger and USB cable.
o
Pen drive with SW + Manual.
2.
Installation
2.1. Battery operation and charging
The instrument is equipped with in-built Li-Ion battery. The fully charged battery will stand more than 20
MAGX2 tests.
In order to charge the battery, connect the Charger to POWER/CHARGE slot in the VeriMAG2 top. The
charging starts automatically.
The battery charger automatically disconnect when the battery is fully charged.
The charger might work as a power supply.
Electrical installation should only be done by a qualified person. Standard safety
regulations for hazardous electrical installations have to be respected.
