MAGE1 User Guide
6
V1.5 12-1-2022
3. MAGE1 Unit
The MAGE1 flowmeter consists of the motherboard, a graphical display, touch-buttons and sensor housing.
Through the display and with help of the controls, you can see and change flow and totalizers.
The following symbols are used in this manual and on the flowmeter display.
3.1. Main screen
Note:
these are not pushing buttons, to activate hold your finger over the white rectangle for 2 to 4 seconds.
On/Off
Turns the meter on, switching the meter off.
Batch Reset
Clears the Batch volume.
Batch/Total
Switches between totalizers.
Combination On/Off and Batch/Total together
Changes the unit of a system (l/s and USG/min, resp. litres and gallons, etc.)
Total Volume
This is the total volume counter. Negative flow is not counted.*
Batch Volume
This counter works the same way as Total Volume. Both counters are independently clearable.*
*
If value of any Volume counter higher than 4 000 000 m3, than value of Volume show only in m3 unit. If value of any Volume counter higher than
999 999 999 m3, then this Volume will be reset to 0
Volume
Flow Unit
Actual totalizer
Flow Unit
Volume Total
Actual Flow
Permanent
operation
Currently
pressed button
Empty pipe
detector
Summary of Contents for MAGE1
Page 1: ......
