Arkbird FPV
-20-
4. Based on how far and high expect to fly, adjust
safe height
as high as possible (If fly far than 2km, please
adjust this value more than 150m). Please set cruise speed as “
Safe speed
” in RTH menu.
11
FAQ and Solutions
：
★
When switching to Balance Mode, the elevator will lift up a bit because the “Elevate Angle in a level flight” in
the menu is defaulted as 5°. Which means the plane will rise a bit in a level flight to ensure a level route.
★
If the aileron has touched the edge which prevents you entering the menu, please check if the route setup is
too small on the remote control.
★
It’s normal when the direction of compass and return arrow is inaccurate while testing on the ground. The
data will be calibrated by GPS in 10s after the plane takes off.
12
Other FAQ
：
Q
：
There is no OSD / OSD is
incomplete
A
：
Check the wiring, restart the power.
Notice that if separated supply, the
sequence to power on
is OSD 12V first, and then ESC
flight power
.
Otherwise, the OSD cannot initialize and display.
If there shows OSD but incomplete, check PAL/ NTSC signal custom option or change display device, some
USB-AV card output is incomplete
Q
：
OSD disappear once plugged the camera
A
：
Change PAL/ NTSC option, use mainstream FPV specialized camera, some surveillance camera is compatible.
Q
：
Cannot locate home, displaying “Waiting GPS Home”
A
：
Seeing OSD “Waiting GPS Home” proves GPS wiring is OK, otherwise, please check GPS wiring.
GPS’s white antenna shall face up; keep GPS away from Video TX and Camera. Some inferior Video TX’s
antenna will affect GPS, too. You can try to remove the casing of GPS, or put a layer of tin foil paper under GPS to
enhance the performance.
GPS can only work Outdoors, First time about 5-10 minutes, next power on of the same day it would take
less than 10seconds to locate.
Q
：
Plane tilts under Balance Mode / Manual Mode, can I adjust the radio TRIM
A
：
First time installation, do a
neutral point alignment
. Radio stick and SUB-TRIM back to center, adjust plane’s
CG and travel angle to make plane balanced.
Arkbird can produce compensation when CG & travel angle is not appropriate, but it is not mechanical
stable, there would be hidden trouble under RTH mode. So firstly make sure plane can fly stably in horizontal
under Manual Mode.
Q
：
Inaccurate Return-To-Home
A
：
Adjust remote control rudder angle to 100% and sub-trim back to center. Check carefully in reference to the
