![Arkbird FPV OSD V3.1028 Manual Download Page 11](http://html.mh-extra.com/html/arkbird/fpv-osd-v3-1028/fpv-osd-v3-1028_manual_2972617011.webp)
Arkbird FPV
-11-
7
Manual Mode
Radio Stick and SUB-TRIM back to center, set radio travel range as 100%.
Switching to Manual Mode
, Arkbird will not participate control, set
manual control’s reverse
through
radio, adjust plane’s CG and travel angle, make sure plane can fly stably in horizontal without Autopilot.
Reverse Balance Mode assistant Control
Switching to Balance Mode
by pushing CH5 to 100% and CH6 to 0%, if the neutral point is correct,
rudder, aileron and elevator shall be at the neutral position, otherwise, please check the neutral point again.(see
OSD menu -> CTL parameters)
1.
Aileron
: When rolling the plane to right, aileron shall produce a left compensation automatically, make
plane go back horizontal. On the contrary, when rolling to left, aileron will produce a right compensation. Please
see as below:
If the compensation direction is not correct, please move the Dip switch 1 to the other side.
2.
Elevator
: When pitching up the plane, elevator shall produce a down compensation automatically. On
the contrary, when pitching down, elevator will produce an up compensation. Please see as below:
If the compensation direction is not correct, please move the Dip switch 2 to the other side.
3.
Rudder
: When yawing the plane to right, rudder shall produce a left compensation automatically. On
the contrary, when yawing to left, rudder will produce a right compensation.