Arkbird
- 4 -
2.
12V power supply is on the base frame. Connect RCA to the display or DVR;
3.
Power on after correct wiring;
If ground GPS module is plugged in, the red "HOME LED1" will double flash. If the ground module locates
the correct coordinates of
take-off point
, the red LED1 will flash fast.
If the video communication works normal, the yellow "VEDIO LED2" will double flash. If airborne module
locates the correct coordinates of
the plane
, the yellow LED2 will flash fast;
If the audio communication works normal, the green "AUDIO LED3"will flash fast;
(When you have just powered on the device without positioning and the communication is normal, "HOME
LED1" will flash slowly as "VEDIO LED2" double flashes and "AUDIO LED3" flashes fast ;)
After airborne module positioning is completed, the ground module will save HOME coordinates once and
shift into tracking mode automatically.
Make sure that LED on the airborne module and three LED lights on the
ground module are flashing fast before launching the plane.
Notes: If GPS module is connected to the ground module (optional; as shown above), it will use the ground
GPS automatically to real-time update HOME coordinates and give directions for dynamic positioning. The
change in position of ground module is allowed while tracking.
When there is no video signal, AAT will point to the latest identified coordinates before you lost your
signal.
Remember to keep the ground module powered-on, or the information of the last coordinates will be lost.