Arjohuntleigh Malibu, Instructions For Use Manual, Page: 35 / 60

35
14 Make sure the flow meter shows the right mix ratio as stated
in the IFU , adjust if needed. Lower the water temperature to
approximately 20 °C (68 °F). (See Fig. 5)
15 Spray/shower disinfectant in drain. Use a long handled
brush to scrub drain.
16 Close the drain.
17 Spray disinfectant using the disinfection handle on all
internal bathtub surfaces, lift arm, transfer chair and the
loose parts and the accessories at the bottom of the bathtub.
Turn the loose parts and the accessories and spray on other
side. Pay attention to parts and knobs and sensors attached
to the bathtub surface such as drain control knob/surface
overflow outlet.
18 Spray into the surface of overflow outlet. (See Fig. 5)
19 Scrub the surfaces of bathtub, loose parts and accessories
with a soft bristle brush or cloth (to remove any deposits e.g.
skin flakes). Scrub thoroughly, especially on handles and
hand control.
(See Fig. 6)
20 Open the drain.
21 Rinse all parts clean with plenty of water having a
temperature of approximately 25 °C (77 °F) using the
shower handle to remove disinfectant.
22 Soak a cloth in disinfectant.
23 Wipe all other contact areas such as the outside of the
bathtub (particularly behind the head), metal sensory knobs,
hand control and the wheel chassis (optional) with the cloth.
24 Wet a new cloth with water and remove all traces of
disinfectant on contact areas. The cloth should occasionally
be rinsed in running water when removing disinfectant.
Continue with the steps on the next page.
Fig. 5
Arjo Clean (50)
Fig. 6