13
Part Designation
The following refers to Fig. 4 on previous page:
•
The yellow charging light flashes while charging
and goes solid when charge is finished.
•
The green power light illuminates once the lift is
on and ready for use; the green light flashes when
the batteries are low.
•
The red light illuminates to confirm that the lift is
in the programming mode.
•
The red light also illuminates in the normal mode
when the lift goes into overheat protection caused
by overuse.
•
The red light flashes when servicing is required
(contact customer service).
Handset
The
Maxi Sky
600
’s handset unit is used to operate the
ceiling lift . Each funtion is described in Fig. 5. The
UP
and
DOWN
buttons raise or lower the spreader bar.
With the four-function model, the
LEFT
and
RIGHT
buttons activate a lateral motor to move the lift along
the track. If you have a two-function model, the
LEFT
and
RIGHT
buttons will not function, and the lift must
be moved manually.
The
PROGRAMMING
MODE
button allows you to
modify the functions of the lift. Refer to the “
Maxi
Sky
600
Programming” section for more information.
Fig. 5
button
button
button
button
RIGHT
DOWN
UP
LEFT
CHARGE
PROGRAMMING
MODE
button
700.136XX HANDSET
button
button
button
UP
LEFT
button
button
RIGHT
DOWN
RETURN
TO
CHARGE
button
700-138XX
HANDSET
PROGRAMMING
MODE
button
RETURN
TO
Chargers
The
Maxi Sky
600
units are equipped with either a
cord-connected universal charging system
(#700.15500) or a wall-adapted charger (#700-
15501) that can both be customized to fit the AC
voltage outlets where they are sold (see Fig. 4).
ECS Track System
(For
Maxi Sky
600
ECS Only)
The Maxi Sky 600 is also available for use with the
KWIKtrak Enhanced Charging System (ECS). This
track system allows the cassette to benefit from
continuous charging wherever it is on the track. It
eliminates the need to send the unit back to the
charging station after the patient transfer.
With the ECS option, the “return to charge” (RTC)
feature is thus no longer obligatory. However, this
feature can still be used to store the cassette at the
end of the track, (using a preprogrammed position or
FIDO station) until the next transfer. Since the RTC
is disabled by default, please refer to the “
Maxi
Sky
600
Programming” section of this document for
instructions on how to enable this feature, that for the
ECS is called the “return to home” (RTH) feature.
Please see the “How to Use the
Maxi Sky
600
” section
in this manual.
