User Manual for CD3403
Page 7
U
SING THE ALARM SYSTEM
This chapter explains how to switch on and off an alarm system. Depending on how the system has been
programmed, you may not need to do all the steps shown in the instructions.
If you enter the wrong code 10 times consecutively, the system is automatically locked for 90 seconds.
During this time you cannot access the system.
A
RMING A SYSTEM
Before you can arm, that is switch on, the alarm system, all intrusion zones must be secure. If a zone in the
premises is ‘open,’ that is its doors, windows, etc. are not properly closed, you will not be able to set the
alarm in that zone, and the message ‘Open zones’ will appear on the display. It will also show you which
zone(s) are open. You must then check that the doors, windows, etc. protected by the zone(s) shown on the
display are properly closed.
1.
Go to the keypad. The current date and time appear on
the display. An example is shown.
TUE 23 APR 07.39
2.
Press the key
0
and then enter your code. A ‘*’ appears
in the display for every key you press. Use the
0
key to
cancel an incorrect entry and to start a new entry.
Enter Code
0 + code
Enter Code ****
Arm Menu
3. Press
the
Accept
key.
Normal Set
4. Press
the
Accept
key again.
If the system cannot be armed because there are zone(s)
in the premises which are not properly secured, the
message
‘Open Zone(s)
’ will appear and a list of the
zone(s) not closed. Press the
0
key to quit and check the
doors, windows, etc. of the zone(s) identified.
Normal Set
For information about excluding open zones, refer to the
section ‘Arming a system which has open zones’ on page
8.
The alarm is being set.
System Arming
System OK
The buzzer begins to beep. You must now exit the
protected area by the designated route.
Leave now
Beeeep
