Page 10
User Manual for CD3403
3. Press
the
Accept
key.
Finished?
4. Press
the
Accept
key to confirm that you have finished.
Steps 3 and 4 may be automated by the system. If so,
you will not have to press the
Accept
key.
TUE 23 APR 07.40
D
ISARMING A SYSTEM AFTER AN ALARM
The bell and the flashing light are activated when an alarm is triggered in the system. If your system has the
option, a report of the event is automatically sent over the phone lines to a central station. If you
inadvertently activate an alarm, immediately telephone the central station to prevent an unnecessary
response.
When you enter the premises after an alarm, the bell may already be silent.. This allows there to be several
alarms. Remember to record the fault or alarm in your logbook for future reference.
1.
Go to the keypad. The entry period starts as soon as
you open the entrance door, or when you enter the entry
zone. You can switch off the system without activating
the alarm as long as the beeping continues.
The
red
ALARM
LED is lit on the control panel.
Beep Beep
The current day, date and time are displayed. An
example is shown.
TUE 23 APR 07.39
2.
Press the key
0
and then enter your code. A ‘*’ appears
in the display for every key you press. Use the
0
key to
cancel an incorrect entry and to restart a new entry.
Enter Code
0 + code
Enter Code ****
Disarm?
3. Press
the
Accept
key.
A list of triggered zones will be displayed.
Events in Log...
In this example, the alarm was triggered in zone 4 ‘Back
Door’ on 23 April at 5.20 am.
04 Alarm
04 Back Door
23 APR 05.20
4. Press
the
Accept
key to confirm the alarm.
System Disarmed
TUE 23 APR 07.40
