3
Pre-Installation
- continued
Typical equipment required:
electric drill, screwdriver, tape measure, spirit level
duct tape, jig saw, ladder
(if ducting)
Torch
(If natural lighting is insufficient)
Contents of packaging:
1x Range hood
1x
φ
150mm round ducting
7x Wall Plugs
7x Long Wall Screws
3x Chimney Screws – Pointed End, 12mm in length
2x Chimney Bracket Screw – Flat End
2x Chimney (top & bottom)
2x Mounting Brackets, (1x Wall Mount, 1x Chimney Mount)
Appliance Details:
Voltage & Frequency: 220-240V 50Hz
Lamp max: 2x2W DC12V
Rated Input Power: 274W
Ducting Options
The method of ducting should be carefully considered before installing the range hood. The guide below
recommends the ducting components to use for all common ducting configurations - through the top of the home
(for the roof and soffit) and through the rear of the home. 150mm round ducting should be used in conjunction
with this model range hood. Alternatively this range hood can be operated in recirculation mode (see
Recirculation mode).
The highlighted area in the table below gives the recommended Uniduct item numbers for different
mounting and outlet options.
Duct mounting option
Rear
Top (roof)
Top (soffit/eave)
Extra lengths and/or bends may be required, depending on the length required and whether there is any
structural material in the run e.g. rafters. Please note that this chart is designed as a guide.
