19
NetVisor UNUM High Capacity User Guide: 2022.6.3.2
Network Connections (cont'd)
High Capacity Appliance Network Interface (cont'd)
NOTE:
Eth1 connections are not configured on a VLAN, please contact Arista Technical support if one of
the following must occur:
·
More than one Arista NetVisor UNUM High Capacity Appliance plugged into the same switch (by
default, all appliances come with the same pre-configured Eth1 IP addresses), and each Appliance
isolated in a separate and dedicated VLAN.
·
You want to change the default Eth1 IP Addresses of:
172.16.250.150 - 172.16.250.162
.
5. Connect VGA console and IPMI as desired. IPMI default configuration is DHCP.
6. USB connections are not advised.
7. The Arista NetVisor UNUM High Capacity Appliance, comes with the Arista NetVisor UNUM software
pre-installed.
8. Upon boot up, by default Arista NetVisor UNUM will use DHCP to obtain a Management / eth0 IP
address. If a Static IP is desired, see
Appendix B
.
9. It is highly recommended that the default root password of your Server nodes be changed from test123.
NOTE:
It is required that all Server nodes have the same root password.
To change the root password of your Server nodes, you can do the following: