arietta ASG430SSA, Installation Instruction Manual

Page: 5 / 32

5
A
A
A. Air exhaust transition
NOTE:
The exhaust adaptor/damper can be installed up to 1
inch on either side of the hood center to accommodate offcenter
ductwork. In extreme offcenter installations, one end of the duct
connector may need to be trimmed to clear the electrical cable
clamp.
Mark holes
Select the vent option that your installation will require and proceed to
that section:
Outside top exhaust
(Vertical duct– 3
1
⁄
4
”x 10” Rectangular)
Use the diagram or the hood as a template and mark the locations on
the cabinet for ductwork, electrical wiring and keyhole screw slots. It
is recommended to make the marks before the cabinet’s installation.
13
⁄
32
” (1 cm ) Wiring access knockout
(cabinet bottom side)
Mounting
screws (4)
Cabinet
front side
30” model: 6
11
⁄
32
” (16.1 cm)
36” model: 9
11
⁄
32
” (23.7 cm)
Vent
system hole
5
1
⁄
2
”
(14 cm)
5
1
⁄
2
”
(14 cm)
4
21
⁄
64
”
(11 cm)
7
7
⁄
8
”
(20 cm)
7
1
⁄
2
”
(19 cm
)
2
9
⁄
16
”
(6.5 cm )
13
⁄
32
”
(1 cm )
Vent
shims
CENTER
LINE
Cabinet
bottom side
Venting through the roof Venting through the wall Non Vented (recirculating)
A
B
C
F
F
A
B
D
F
C
A
B
F
A C
E D
A. 3
1
⁄
4
” x 10” rectangular transition
B. 3
1
⁄
4
” x 10” duct
C. Cabinet
D. 90° elbow
E. Round recirculating grid
F. Installation height (above the cooking surface):
MIN: 30” (76.2 cm)
MAX: 36” (91 cm)
Installation instructions
Ducting version
After having chosen the vent option, proceed as follows:
• Prepare duct and conduit cut outs as needed.
• If possible, disconnect and move freestanding or slide-in
range from cabinet opening to provide easier access to rear
wall.
Otherwise put a thick, protective covering over countertop,
cooktop or range to protect from damage and debris. Select
a flat surface for assembling the unit. Cover that surface with
a protective covering and place all canopy hood parts and
hardware in it.
• Determine and mark the centerline on the wall where the
canopy hood will be installed. Select a mounting height
comfortable for the user and mark on wall.
• Prepare duct and conduit cut outs as needed.
• Remove the duct knockouts using a flat blade screwdriver
and a small hammer.
• Use the screwdriver by knocking out the pannel in similar
fashion to a scalpel.
• Take care of sharp edges.
B
A
A. Vertical discharge
B. Horizontal discharge
• Attach air exhaust transition over knockout opening
with 4 - 4x8 mm screws.