EN - 15
4. Align shear bolt holes in auger with shear
bolt holes in shaft.
5. Insert bolts through holes.
6. Secure bolts with nuts.
7. Tighten bolts to 7.9 – 16.5 N•m
(5.8 – 12.2 lbf-ft). If a torque wrench is
unavailable, tighten bolts until they no
longer spin freely. DO NOT overtighten.
Discharge Chute
ADJUST HANDLEBAR HEIGHT
1. Place unit in service position (see
Figure 13) and remove bottom cover.
2. Remove top mounting bolt from both
sides of handlebar. Retain bolts.
• To raise handlebar, push handlebar
down and install bolts in lower mounting
holes.
• To lower handlebar, pull handlebar up
and install bolts in upper mounting
holes.
3. Check tension on speed selector lever
and adjust if needed. See
4. Check tension on auger and traction
clutch cables. See
on page 20.
5. Reinstall bottom cover and return unit to
operating position.
Figure 17
Figure 18
ADJUSTMENTS
WARNING:
AVOID INJURY.
Read and understand the
Safety
section before proceeding.
Figure 19
1. Top Mounting Bolt
2. Lower Mounting Hole
3. Upper Mounting Hole
