EN - 13
Position Drift Cutters
Use drift cutters if snow to be cleared is
higher than auger housing.
1. Loosen wing knobs and move drift cutter
down. See Figure
2. Rotate drift cutter forward 180 degrees
until notch engages upper wing knob.
Tighten wing knobs.
3. Repeat on other side.
Clear a Clogged Discharge Chute
1. Stop engine, remove key and wait for all
moving parts to stop and for hot parts to
cool.
2. Use the snow clean-out tool to clear the
clog.
3. Return the tool to its storage position on
the auger housing.
STOP THE ENGINE
1. Release traction drive clutch lever.
2. Run auger / impeller for a few minutes to
remove loose or melting snow to prevent
impeller from freezing.
3. Release attachment clutch lever.
4. Move throttle control lever to the slow
position.
5. Turn engine key to stop position and
remove key.
6. Turn fuel valve to off position.
MOVE UNIT MANUALLY
• To disengage transmission and move unit
with the engine off, pull the bypass rod
outward.
• Push the rod in to engage the transmission
for normal operation.
Figure
15
Figure
16
WARNING:
NEVER use your
hand to clean out discharge
chute.
Figure
17
Normal
Operation
Move Unit
Manually
