EN – 51
See Figure 125.
14. Remove hardware retaining bearing(s) and remove
bearing(s).
IMPORTANT:
Bearing plate is not a wear item and does
not need replacement unless damaged.
Install Right Bearing
IMPORTANT:
Bearing plates are ONLY installed with
bearing on frame. Bearing plates are NOT installed with
bearing on track carriage.
1.
Secure each bearing to frame and / or side plate with
three hex bolts and three center locking flange nuts.
Reinstall pinion gear into chain. Make sure gear teeth
are correctly seated in chain.
3.
Align pinion sprocket with hole in frame and so chain
is taut.
4.
Position sleeve bushing between pinion sprocket and
frame.
5.
Slowly insert pinion shaft through pinion sprocket,
sleeve bushing and frame until it stops.
IMPORTANT:
Make sure roll pin in opposite end of pinion
shaft is tight against frame exterior. See Figure 127.
6.
Position sleeve bushing against frame and reinstall
spring clip into pinion shaft. See Figure 123.
Figure 125
1. Bearing
2. Bearing Plate
Figure 126
Figure 127
