Ariens 920025, Service Manual, Page: 23 / 60

EN – 19
See Figure 35.
8.
Check attachment brake:
• When attachment clutch is disengaged, brake must
contact attachment belt or pulley, whichever is
closest.
• When attachment clutch is engaged, brake must be
more than 1.6 mm (1/16") away from attachment belt
or pulley, whichever is closest.
IMPORTANT: If attachment clutch / brake is out of
adjustment, refer to Operator’s Manual for adjustment
procedure.
4. Reinstall bottom cover and secure with six hex
screws.
5. Return unit to operating position.
6. Reconnect spark plug wire and fill fuel tank.
IMPORTANT: Check all adjustments after first use.
FRICTION DISC REPLACEMENT
Remove Friction Disc
IMPORTANT: Save all hardware for reinstallation.
1. Stop engine, remove key and wait for all moving parts
to stop and for hot parts to cool.
2. Disconnect spark plug wire from engine.
3. Place unit in service position. See Service Position on
page 7.
4. Remove hairpin from adjustment pin and remove pin
from shift arm. See Figure 35.
WARNING: AVOID INJURY. Auger / impeller
must stop within 5 seconds when attachment
clutch lever is released.
1. Attachment Belt
2. Attachment Pulley
3. Brake Pad
Figure 35
1
2
3
WARNING: AVOID INJURY. Before placing unit
in service position, drain fuel from tank and fuel
system. See
Draining Fuel System on page 7.
Make sure unit is secure and will not tip.
Figure 35
1. Speed Selector Arm
2. Hairpin
3. Adjustment Pin
1
3
2