Ariens 915209 - Zoom 34 CARB, Operator'S Manual

Page: 25 / 40

EN - 25
The Forward Pitch Of The Mower
Blades
(Figure 13)
• Front tip of blades should be
0 – 0.6 cm (0 – 1/4") lower than the
rear of the blades.
NOTICE: This measurement must be taken
when the mower blade ends point forward.
The Pitch Of The Mower Blades From
Side To Side
(Figure 14)
• Should be within 0 – 0.6 cm
(0 – 1/4") as measured on each side of
the mower deck.
NOTICE: This measurement must be taken
when the mower blade ends point left and
right.
Adjusting The Mower Deck To Adjust
Mower Blade Height And Pitch
(Figure 15)
NOTICE: Adjusting the mower deck will
adjust the height and pitch of the mower
blades.
1. Adjust the trunnions first and re-take the
three measurements required to level
and adjust the pitch of the mower deck.
These measurements are:
a. The distance from the mower
blades to the ground.
b. The forward pitch of the mower
blades.
c. The pitch of the mower blades
from side to side.
Adjust Trunnions:
1. Using an adjustable or open ended
wrench tighten or loosen the lock nut on
top.
NOTICE: To avoid over-adjustment note
which nuts have been adjusted and the
amount each has been loosened or
tightened.
2. Using the same tool, tighten the bottom
hex nut to raise the deck OR loosen the
bottom hex nut to lower the deck.
3. Tighten the lock nut on top to secure the
link in the desired location.
4. Repeat step 1 as needed until all three
measurements (a, b, and c) are within
the tolerances specified.
Forward Pitch of Mower Blades
Figure 13
1. Mower Deck
2. Mower Blade
3. Ground
Forward Pitch = 0 – 0.6 cm
(0 – 1/4")
Front of Mower Deck
2
3
1
Figure 14
1. Mower Deck
2. Mower Blade
3. Ground
1
3
2
Side to Side Pitch
0 – 0.6 cm (0 – 1/4") from Side to Side
Figure 15
1. Trunnion
2. Mower Deck
3. Lock Nut
4. Hex Nut
1
2
3
4