- Translated original instructions -
0040501006 2422
Page 2-33
Operating and installation instructions
Thrust actuator ARI-PREMIO
®
-Plus 2G
5.7.1.5 Operation – Programming / clearing positions
Fig. 17
Programming
Procedure
Relay 1
- Approach the spindle position.
- Press "Relay 1 button (up)" until the corresponding LED blinks once.
- From now on, relay 1 is switched to "active" when the current position is
overtravelled in the UP direction.
Relay 2
- Approach the spindle position.
- Press "Relay 2 button (down)" until the corresponding LED blinks once.
- From now on, relay 2 is switched to "active" when the current position is
overtravelled in the DOWN direction.
Clear
- Press "Relay 1 button (up)" AND "Relay 2 button (down)" simultaneously
for longer than one second
- Both LEDs blink once to confirm the new setting.
- From now on, the two relays are no longer switched.
Overwrite
Similar to Prog. Rel.1 or Prog. Rel.2.
The new position automatically overwrites the old position.
Test
Move the spindle to and fro with any type of control (e.g. MAN switch) and
watch the LEDs.
"Relay 1" LED (up)
"Relay 1" button (up)
"Relay 2" button (down)
"Relay 2" LED (down)
