2. Install the Bracket
The bracket can be adjusted at two different points:
1.
Adjusting the ball joint (A). The bracket allows rotating the ball joint in a 35-degree spatial angle in any
direction.
2.
Adjusting the foot (B). If the necessary extent of rotation exceeds 35 degrees then the foot of the bracket
can be rotated by 180º extending the 35 degree spatial angle with additional 20° according to the figure.
B
A
Bracket foot rotated by 180°
enables additional 20°
to rotate the camera by.
Steps of rotating the foot
1. Remove the four screws (
1
) located at the back of the foot. (Use size 4 Allen key).
2. Rotate the foot (
2
) by 180 degrees.
3. Place the screws back into the holes and screw them back on.
NOTE
: Do not overtighten the screws.
1
1
1
1
2
Page 6/15
Page 6/15
ParkIT Install Guide
