Argo Kobra +2 Series, Instruction Manual

Page: 12 / 16

12
EN
© arGO s.a. www.argo.pl
cover (D), insert the magnetic data support in the slot (H) in the hand guard flap (E) and
close the transparent swinging cover (D) again.
The machine will start up automatically for a shred cycle lasting approx. 15/17 seconds
and stop automatically.
IMPORTANT:
only insert one data support at a time in the slit (H) in the hand guard (E).
Do not insert cDs, DVDs and credit cards in the front slit designed for paper as the cutting
blades for shredding paper are not suited to shredding cDs, DVDs and credit cards.
In order to prevent paper jams caused by too much paper being inserted at one time
it is advisable to operate the machine at less than full shred capacity. This will pro-
long the life of mechanical parts and the machine itself.
eneRGy sMARt
Functions: approx. 12 seconds after shredding is finished, the machine automatically go-
es into Energy saving Mode. The ENErGY sMarT light (B) goes off reducing power con-
sumption to virtually zero.
This function gives an annual energy saving of around 10 kiloWatts, a reduction of 65kg on
carbon Dioxide emissions into the atmosphere (the cause of the ozone hole).
as soon as sheets of paper are inserted into the front slit, the electronic eyes are activated
or the transparent swinging cover (D) is raised and closed again, all machine functions are
automatically reactivated. The ENErGY sMarT light (B) comes on to indicate that machine
functions have been reactivated.
The transparent swinging cover (D) makes it possible to check on shredding in progress
at any time while protecting the operator from splinters which could be produced during
shredding of magnetic data support media.
The Hand guard Flap (E) serves to provide further protection for the operator and activate
the electronic eyes but also to guide the sheets of paper, cds, DVDs and credit cards fed
into the shredder.
AUtOMAtIC FUnCtIOns
all kobra +2 and kobra + 3 models feature the following automatic functions.
- ELECTRONIC EYES (C) so the shredder starts up automatically as soon as sheets of paper
are inserted into the slit on the front of the machine.
-
TRANSPARENT SWINGING COVER (D)
with automatic cushioned closing.
When the cover is raised all electrical functions are blocked.
simply close the transparent swinging cover again and the cutting head will begin a shred
cycle and restore all automatic or manual functions.
- AUTOMATIC STOP when the waste paper bin (2) is pulled out and/or the transparent
swinging cover (D) is opened.
-
MOBILE PROTECTION SYSTEM
with dual sensors which automatically stop the machine
as soon as the transparent swinging cover (D) is raised.
- MOTOR SAVING FUNCTION which stops the machine working should it overheat.
(if the motor saving function comes on, leave the machine to cool down for at least 10/15
minutes. The machine then starts up again automatically).