54
SECTION 11
ACCESSORY INFORMATION
Figure 11-2. Tire Sizing Chart.
IMPORTANT
PLEASE NOTE THE ABOVE TIRE PRES-
SURES ARE RATIOS AND NOT NECESSARILY
THE FINAL PRESSURES USED. TIRE PRES-
SURE MAY NEED TO BE ADJUSTED HIGHER
OR LOWER TO ACHIEVE CORRECT TRACK
DEFLECTION. E.G. TIRE PRESSURE MIGHT
END UP AT (4,6,6,5) OR (3,5,5,4) ETC. HOW-
EVER, DO NOT EXCEED THE MAXIMUM
TIRE PRESSURE OF 7PSI ON ANY GIVEN
TIRE AS INDICATED ON THE SIDEWALL OF
EACH TIRE.
IMPORTANT
BEFORE INSTALLING THE RUBBER
TRACK SYSTEM, IT IS CRITICAL THAT
TIRE SIZING IS PERFORMED AND THE
TIRES INSTALLED AS SHOWN IN THE
CHART (Figure 11-2). PLEASE REVIEW AND
ENSURE YOU HAVE FOLLOWED THE PRE-
VIOUS INSTRUCTION BEFORE PROCEED-
ING WITH THE FOLLOWING:
e. Using a 3/4" socket, install the wheels and torque nuts.
55 ft. lbs
.-
(75 Nm)
Standard Beadlock/Chrome Nuts.
35ft.lbs
-
(47 Nm)
Black Eco-Guard Nuts.
11.3.2 Installation Rubber Track System
1. Install the Hinge Assembly as described in the rubber
Track Kit instructions.
2. Lay the two assembled tracks on the floor.
3. Drive the vehicle forward onto the tracks leaving ap-
proximately 8" extending past the front tires.
4. Pull the remaining track around the rear tire and forward
to the front of the vehicle.
5. Deflate the front and rear (or all tires) for easier instal
-
lation of the final track pin.
6. Join the two ends of the track and secure them in place
with C-Clamps as shown in Figure 11-3, so that the holes
of the hinge lacing line up.
Figure 11-3. Securing with C-clamps.
7. Insert the Track Pin through one of the washers and then
through the hinge lacing.
Be sure to install the pin from
the outside edge of the track so the end with the cotter
pin hole ends up nearest the vehicle lower body.
8. Secure the Track Pin in the hinge with a washer and
cotter pin at end closest to the vehicle body.
9. Re-inflate the tires as shown in the chart. With the tires
installed and inflated as shown in the chart, there should
be 2 to 3 inches between the bottom of the second (or
third) tire and the inside surface of the track when the ve-
hicle is elevated. Figure 11-4 & 11-5. This may require
the installation of a track extension or additional hinge
Summary of Contents for Frontier 600 6x6
Page 70: ...62 NOTES...
Page 71: ...63 NOTES...
